USB Car Diagnostic Cable VCDS VAG 106.4 HEX CAN Interfaces
VCDS VAG 106.4 HEX CAN interfaces Description:
Important Note: Beta versions contain new features and functions
that have not yet been as fully tested as have Release versions. If
you use a Beta, you may find bugs or problems and you are expected
to report them to Ross-Tech so that we can fix them before making a
new Release. Please be sure that you have also installed the latest
Release on your computer as well so that you can revert back to
using that if you encounter problems with the Beta.
Vag 106.4 includes the following and improvements:
Communications with all control modules in VW Crafter ("LT3") light
To access Crafter modules individually, click the new "LT3" tab on
the Select Control Module screen:
Support for reading and clearing DTCs (fault codes) in all control
modules in VW Crafter light trucks.
The ability to perform Adaptations in all control modules in VW
Crafter light trucks. This is particularly useful in order to be
able to reset the Service Reminder Indicator. To reset SRI in a
Crafter, click the LT3 tab in the Select Control Module Screen,
then click [96 - Instruments] and you’ll get to a screen like this:
Now click [Adaptation] which will produce the usual UDS Adaptation
On this screen, click the down-arrow in drop-down box labeled
"Channel" and then select "Service interval extension - Reset
Konstante". The precise name of this channel may vary depending on
exact instrument cluster installed in the vehicle, but the correct
channel should not be hard to find:
Once you’ve selected the channel, the Stored value should be four
bytes of hexadecimal data. If the Service Reminder is ON, these
will usually (but not always) be "00 00 00 01". To reset the
Service Reminder, type in a New Value of "00 00 00 00", and click
[Do It!]. After that, you’ll have to confirm that you really want
to do this:
We strongly urge customers not to to alter Adaptation channels
unless they understand the contents of a particular channel.
Improved CAN TP2.0 Retry Scheme for more reliable communications.
Fixes for module-mapping hang-ups in some late-model radios.
Support for new VW control module addresses.
New version 1.84 firmware for HEX+CAN interfaces restores VAG-Saver
functionality even when "Boot in intelligent Mode" is active.
Enhanced Subsystem ID info in Auto-Scan.
Updated CODES.DAT file now with over 16, 000 codes.
Release Notes:Works only with Intelligent Interfaces (HEX, KEY and
Micro-CAN). Default installation location is C:Ross-TechVCDS-Beta.
If allowed to install to its default location, it will not
overwrite or interfere with the use of Release 10.6.For VW Crafter
"LT3" control modules, this version supports the following
functions: Control Module ID and Advanced ID, Fault Codes (Read and
Clear), Supported Codes, Security Access, and Adaptation. Other
functions such as Measuring Values, Output Tests, and Basic
Settings will be added in future versions. Most Crafter modules
require a module-specific "data dictionary" file. If a data
dictionary file is not available for a specific control module,
VCDS will show an obvious error message, in which case you should